SPONSORS
2024 ICRBE EXPO |
Results 1 - 30 of 209
8 years ago
Chad Barlongo
Built this as a heavy bait-cast/light slide-bait ulua (GT) rod..
Forum: rodboard 8 years ago
Chad Barlongo
<p>Trim wrap has been extended up, and onto, the metal tip-top tube locking it in place. Without color preserver, it is easy to see just how much of the tube has been wrapped.</p>
Forum: rodboard 9 years ago
Chad Barlongo
<p>A little something to match the guide wraps..</p>
Forum: rodboard 9 years ago
Chad Barlongo
<p>Last night I decided to try my hand at marbling. First I mixed WAY too much pigment. Next I made the mistake of brushing the colors out, instead of letting them do their thing. Third time was the charm.</p>
Forum: rodboard 9 years ago
Chad Barlongo
<p>Last night I decided to try my hand at marbling. First I mixed WAY too much pigment. Next I made the mistake of brushing the colors out, instead of letting them do their thing. Third time was the charm.</p>
Forum: rodboard 9 years ago
Chad Barlongo
<p>Crosswrap layout using diamond templates as described by John Powell..</p>
Forum: rodboard 10 years ago
Chad Barlongo
Here is a black frame Hardloy guide pictured next to my gray frame Fuji.
Forum: rodboard 10 years ago
Chad Barlongo
Possibly a Hardloy? I know they come in black and shiny silver frames, but satin-gray...has anybody seen one like this before?
Forum: rodboard 10 years ago
Chad Barlongo
Here are the two gold metallics in question which I tested. One coat of color preserver for the two wraps on the left, no color preserver for the two on the right...Thin coat of finish, no flaming, and yet these waves still showed up.
Forum: rodboard 10 years ago
Chad Barlongo
This was going to be an under-wrap. Almost looks like too much finish was applied, but like mentioned in my forum thread....Finish was applied thin and allowed to saturate...I also stopped the motor to wick off any excess finish. In further tests these waves and wrinkles would show up within minutes and only get worse....no matter how much finish was removed.
Forum: rodboard 10 years ago
Chad Barlongo
<p>Just wanted to share my finished rods. Thanks RB for your help with this build.</p>
Forum: rodboard 9 years ago
Chad Barlongo
27. JT Olivebranch
<p>Just a wrap I did for fun..</p>
Forum: rodboard 6 years ago
Chad Barlongo
29. Re: Wrapping 101
Hello,
When you say "indentation", I take it you are referring to the edge of the wrap not being perfectly straight? i.e. the edge is pushed in a bit, at the point where the tag end was pulled through. If so, you might try using a smooth cylindrical burnishing tool to gently roll out (not rub) the wrap, in the direction it needs to go.
Pinching down the wrap and pulling the tag en
Forum: rodboard 6 years ago
Chad Barlongo
It has been awhile since I placed an order, was pleasantly surprised by the new rates.
Thank you Team Mudhole!
chad
Forum: rodboard |