SPONSORS
2024 ICRBE EXPO |
Does Batson make LTCFNG in sizes smaller than 6?
Posted by:
Marty Martin
(---.gsp.bellsouth.net)
Date: January 11, 2011 11:48AM
I'm contemplating what would look good on a XSB820.75 (ti-chrome finish) with an ABU Revo which has Tich trim and a gold ring on the levelwind. That would give the whole thing a Black/Tich/Gold look.
Also, what thread color goes well with the RX8 blanks? I have metallic pewter. Would that be a close match if I wanted the wraps to blend in? Re: Does Batson make LTCFNG in sizes smaller than 6?
Posted by:
Bob Grobolsek
(---.mcleodusa.net)
Date: January 11, 2011 01:04PM
I just finished a couple of test wraps on a RX8 XSW72ML using Pac Bay metallic pewter. No CP and the wrap about disappeared. Re: Does Batson make LTCFNG in sizes smaller than 6?
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: January 11, 2011 01:17PM
ALPS micro guides are on the way
I have some of the TCMNG 3mm-5mm in that color But as to whom will be stocking the ALPS Micro's in that color scheme is up to each vendor to decide. Edited 1 time(s). Last edit at 01/11/2011 01:18PM by Steve Gardner. Re: Does Batson make LTCFNG in sizes smaller than 6?
Posted by:
Jim Gamble
(97.106.17.---)
Date: January 11, 2011 01:46PM
To get wraps to "disappear" you need to use a nylon thread (not metallic and not NCP or Stay True) without applying CP. I always pick a color a shade lighter than the blank. Look for something in the gray family and you will be all set. Sorry, only registered users may post in this forum.
|