SPONSORS
2024 ICRBE EXPO |
o-ring size
Posted by:
Michael Sledden
(---.dsl.emhril.sbcglobal.net)
Date: July 03, 2010 09:02AM
Anyone know the exact size of the o-ring for the Renzetti rod supports. I have a place to buy them, just want to make sure I get the correct size. I looked on here with a search and none of the replies I find say the exact size. Re: o-ring size
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 03, 2010 12:57PM
Mike,
It is very easy to go to your local hardware store, go to the plumbing department and pick up the O ring of choice that will fit your rod suppoirt for about 15 cents each. Roger Re: o-ring size
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 03, 2010 12:58PM
Mike,
The only purpose that O rings serve is to cushion the rod from the rollers. Any O ring that fits will work just fine. If they break or wear out or rot, simply put on another one. Roger Re: o-ring size
Posted by:
Jim Williams
(---.br1.sho.az.frontiernet.net)
Date: July 04, 2010 04:11PM
My local small town Ace Hardware has "O" rings. I purchased a larger ring with a smaller diameter O ring from them for a different purpose. I cannot say for sure they have the O rings you want because I only looked for what I wanted. They seemed to have a good selection of O rings though. Sorry, only registered users may post in this forum.
|