SPONSORS
2024 ICRBE EXPO |
How to remove a tuff but from a blank?
Posted by:
Al Sanders
(---.cst.lightpath.net)
Date: May 04, 2010 03:13PM
I have an old rod and I do not like the tuff butt. I want to put on Hypalon instead. But when I heat the butt its just melts. Should I use a dremel too and cut straight down then pry it off? Re: How to remove a tuff but from a blank?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: May 04, 2010 03:23PM
yes Re: How to remove a tuff but from a blank?
Posted by:
Bob Balcombe
(---.dyn.centurytel.net)
Date: May 04, 2010 06:13PM
You will still have to clean the blank. It must be smooth Good Wraps Bob Re: How to remove a tuff but from a blank?
Posted by:
Peter Sprague
(---.reverse.vilayer.com)
Date: May 04, 2010 08:47PM
Split it straight down and then pop it open like a clam by inserting a screwdriver or chisel in the opening. Sorry, only registered users may post in this forum.
|