SPONSORS
2024 ICRBE EXPO |
AMTAK's A-Frame Spinning Guides
Posted by:
Jess Brindisi
(---.dc.dc.cox.net)
Date: January 07, 2009 07:50PM
Does anyone know the height of these guides? I've looked on the website and can't seem to find the measurements. I know Batson has the measurments with theirs, but just trying to compare.
Thanks Re: AMTAK's A-Frame Spinning Guides
Posted by:
Russ Pollack
(---.mclnva23.covad.net)
Date: January 07, 2009 09:53PM
Comparable to the Batson VS3 guides with the support up the middle. The AmTak guides with the brace across the span are equally strong and resistant to twist.
Either one are better (i.e., stronger) than the Fuji "tall" guides without a brace. Uncle Russ Calico Creek Rods Re: AMTAK's A-Frame Spinning Guides
Posted by:
Lance Dupre
(---.sub-70-218-38.myvzw.com)
Date: January 07, 2009 10:45PM
I believe he was asking what the height of the Am Tac guides were compared to the Batson guides and not comparing the strength of the two brands against the Fuji's. Re: AMTAK's A-Frame Spinning Guides
Posted by:
Ken Preston
(---.hsd1.md.comcast.net)
Date: January 08, 2009 09:01AM
Heights - off blank in mm (inside ring measurements)
Ring diameter bottom of guide top of guide 16 28 38 12 20 31 10 16 26 8 14 21 6 10 15 4 6 9 Comparable in height / clearances to the Batson guides. Re: AMTAK's A-Frame Spinning Guides
Posted by:
Chase Foster
(---.se.biz.rr.com)
Date: January 08, 2009 05:41PM
Hey Jesster, I believe Darrin Heim emailed you a response, and I see Ken answered you as well. Let me know if you need any further info. Thanks Guys! Chase Foster American Tackle www.americantackle.us Sorry, only registered users may post in this forum.
|