Stops the Problem of the Bail Slamming shut while casting ,Losing a Couple 35.00 plugs is not good. Very easy to get used to I made a old "Greenie" Penn 704 into a PENN-Stahl also Bailless
Forum: rodboard

Wrong Info
Forum: rodboard

Gib This is How I Wrap Micros It starts at 72 -75-74 Set foot on top of wrap ,turn a few times pull the foot under and finish up
Forum: rodboard

Screwed in to a reel seat it gives you a Tell Tale that your seat is straight up for aligning Guides by Eye while Wrapping. Just drilled and taped an old Penn Reel seat. Works Well
Forum: rodboard

Saw this in the Newest RodMaker, Been using this for Years!
Forum: rodboard

Try Get Bit
Forum: rodboard

Look at the Commercial Manual Pieces and Mod Your Own
Forum: rodboard

Rod Geeks Blanks DO NOT like DNA! Nick Thank You for a Great Video!
Forum: rodboard

Rod Geeks Blanks DO NOT like DNA! Nick Thank You for a Great Video!
Forum: rodboard

Whole House Vacuum Systems use 2 " thin wall
Forum: rodboard

I'm 67 yrs old been building since 94
Forum: rodboard

I'm 67 yrs old been building since 94
Forum: rodboard

Phil Cou;ld I get that info
Forum: rodboard

LAMI "OLD SCHOOL BLANK"
Forum: rodboard

Cut ,Soak in Boiled water 10 -15 mins untill entire back it saturaed. Peel and apply using thumbs to apply presure while slowly rotating rod.when finished I wrap it with a Sacrifical thread for 24 Hours
Forum: rodboard

Order your Abalone from Kevin,It is the Best And ask him for info. It is really easy using his material
Forum: rodboard

Order your Abalone from Kevin,It is the Best And ask him for info. It is really easy using his material
Forum: rodboard

Order your Abalone from Kevin,It is the Best And ask him for info. It is really easy using his material
Forum: rodboard

Thank You Gentlemen!
Forum: rodboard

Never wrapped any of These guides ,but Seem to remember Stripper guide is reversed? on a 13 ft surf rod
Forum: rodboard

Have Also Had GREAT Customer Service from the GOOD People at Get Bit! I have been called on Sunday When I email with a Problem Order. They Go Above the Line of Duty to assist their Customers
Forum: rodboard

Velco Strap and a Phone cord Bungee
Forum: rodboard

Robert Unhide Your Email for Info
Forum: rodboard

Thank You Joe! Caught me Short with that Email!
Forum: rodboard

Ken yes have them too,elasteic hiar band worked well for stopping complete pull out Barry Its what ever works best for You
Forum: rodboard

Barry; the stretch holders I use are basically the same as hair bands. have had them for years. Did not sand or grind these,they are Batsons and are pretty thin, no problem with grtting thread on them. just moving them back that 1/8 -1/4 to pull the foot back under the thread. Ron; I do not use Guide glue under my guides.
Forum: rodboard

Do not Believe they will workout in Saltwater Trolling. Try Slick Butts
Forum: rodboard

yes, they pop out too easy without
Forum: rodboard

Punishing my Remaining Eyesight by Wrapping Micros on a Gift Rod! I keep pulling the guide from under the wrap while trying to wiggle it back in position. Was really cranking me up! Figured I had to Stop it from sliding too far out. I purchased these elastic bands to hold Guides in position while wrapping. Slid one on the blank and left a little gap for the guide to move into, Worked Great no m
Forum: rodboard

Make a Shelf to hold a Single rod dryer
Forum: rodboard