SPONSORS
2024 ICRBE EXPO |
Results 61 - 63 of 63
9 years ago
Steve Monroe
Stop the rotation, dab a little finish in the area, spread it with the brush and, then start the rotation again to complete the remainder of the finishing. Any brush marks will even out. If you have any old rods laying around cut the guides off and put them back on for practice. It takes a little time to figure out how the finish flows and how you can move it around. This practice should real
Forum: rodboard 9 years ago
Steve Monroe
I have built 1 spinning and 1 casting rod using these. I have used the spinning rod and really liked it. The cast is very smooth. I havent made it out to use the casting rod yet.
Forum: rodboard 9 years ago
Steve Monroe
Are the ones in the 2nd link assembled or just loose parts?
Forum: rodboard |