SPONSORS
2024 ICRBE EXPO |
Source for custom enameled end cap
Posted by:
Marco Cecala
(---)
Date: October 09, 2023 10:17AM
I am doing a custom rod that needs an enameled butt cap. It is a multi-colored logo. Is there anyone out there that can do this? Thanks. Re: Source for custom enameled end cap
Posted by:
Tom Kirkman
(Moderator)
Date: October 09, 2023 04:30PM
I'm sure there is a specialty shop somewhere that could do it. Doubtful they are connected to the rod building world specifically, but I'm sure there is someone that could do it.
Is there any other method you might use? Scrimshaw? Engraving? ............. Re: Source for custom enameled end cap
Posted by:
Marco Cecala
(---)
Date: October 09, 2023 04:49PM
I may have to go that way, Tom. It is a colored logo, and I am getting ideas on having a custom lapel pin made and attaching it to a custom-turned end cap. Re: Source for custom enameled end cap
Posted by:
Norman Miller
(Moderator)
Date: October 09, 2023 05:09PM
There are a number of enamel pin manufacturers that do custom work. I doubt very much they would do just a single piece. So, you would probably need to have multiple copies made. If it’s your business logo might not be a bad way to go. Some of the pin manufacturers do very nice work.
Norm Re: Source for custom enameled end cap
Posted by:
Marco Cecala
(---)
Date: October 09, 2023 05:38PM
Thanks, Norm. I have seen a couple out there and may go with one of them. Sorry, only registered users may post in this forum.
|