SPONSORS
2024 ICRBE EXPO |
Replacement mid section
Posted by:
gabriele schieda
(---.cpe.net.fido.ca)
Date: December 03, 2021 08:03PM
I have a few NFC Hm blanks, I broke one and I want to use the midsection of the other blanks I have. What should be the ferrule measurements. I measured with the new one it seems to go a quarter inch more than the broken one. Is that ok. Cause it's a mid section I have to account for tip and butt. I have 2 3/4 for the butt and 2 1/4 for the tip. That's the amount that goes in. Thanks in Advance Re: Replacement mid section
Posted by:
Herb Ladenheim
(---.68.237.4.hwccustomers.com)
Date: December 03, 2021 10:21PM
If ferrule s fit with out "knocks" - then 1/4" (+) or (-) is no issue at all.
Herb Re: Replacement mid section
Posted by:
Phil Erickson
(---)
Date: December 03, 2021 10:22PM
sounds like a pretty good fit, if the taper isn't markedly different. Re: Replacement mid section
Posted by:
gabriele schieda
(209.171.88.---)
Date: December 04, 2021 12:16AM
Thanks guys Re: Replacement mid section
Posted by:
Tom Kirkman
(Moderator)
Date: December 04, 2021 08:51AM
Ferrule fit is only one problem you may have with this type section replacement.
......... Re: Replacement mid section
Posted by:
gabriele schieda
(---.cpe.net.fido.ca)
Date: December 04, 2021 06:58PM
Tom Kirkman Wrote:
------------------------------------------------------- > Ferrule fit is only one problem you may have with > this type section replacement. > > ......... Fits really good not sure what you mean, the original I am thinking that is why it broke in that area. It was only in 1.25 inch's. It broke around there, I have three Hm blanks, they all were 2.5 inch. Re: Replacement mid section
Posted by:
Tom Kirkman
(Moderator)
Date: December 04, 2021 07:02PM
If the mid section you are using has a different stiffness or flex profile than the original, you may find it creates a stress riser at either ferrule area.
.................. Re: Replacement mid section
Posted by:
gabriele schieda
(---.cpe.net.fido.ca)
Date: December 04, 2021 07:30PM
If it's the same blank it can be different stiffness. Same model Re: Replacement mid section
Posted by:
Tom Kirkman
(Moderator)
Date: December 04, 2021 10:00PM
If it's the same blank model then you should be OK.
............ Re: Replacement mid section
Posted by:
gabriele schieda
(---.cpe.net.fido.ca)
Date: December 04, 2021 10:27PM
Thanks Tom and everyone really appreciate this forum Sorry, only registered users may post in this forum.
|