SPONSORS
2024 ICRBE EXPO |
Detachable fighting butt components for bamboo rod?
Posted by:
Alex Corvin
(---.bb27109.ctm.net)
Date: November 28, 2021 12:55PM
Do you know where I can purchase or who still makes these components of detachable fighting butt for bamboo fly rods? A complete set of reelseat, end cap, detachable tube, and rubber button?
Like this one: [cdn.shopify.com] Thanks Re: Detachable fighting butt components for bamboo rod?
Posted by:
Mark Talmo
(---)
Date: November 28, 2021 02:36PM
Alex,
Does your fighting butt require being built specifically for bamboo rods? I cannot imagine what the difference would be, but then, I am not an avid fly angler. I will be following your post to learn from the veterans such as Phil Erickson and Herb L. I am here to learn. Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: Detachable fighting butt components for bamboo rod?
Posted by:
Phil Erickson
(---)
Date: November 29, 2021 12:51PM
The image looks more like an addition to make it a two handed rod, rather than a fighting butt. I am not aware of a source for the components. Additionally, the rod appears to maybe be fiberglass rather than bamboo. If so, either the fiberglass or bamboo forum might be able to help. Edited 1 time(s). Last edit at 11/29/2021 12:58PM by Phil Erickson. Re: Detachable fighting butt components for bamboo rod?
Posted by:
Tom Kirkman
(Moderator)
Date: November 29, 2021 03:37PM
That's an older rod, probably from the 1960's. Those type components aren't available anymore although you might find an old salmon rod that sports them and carefully remove them for your own use.
.......... Re: Detachable fighting butt components for bamboo rod?
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: November 29, 2021 04:59PM
Hello Alex.
You could make one yourself, using an aluminum tube, a cork grip, and a butt like a1,5 RVB from MudHole. I'm with Tom if you can't find a used one, it will be hard to find a new one. But you could make something close with a tube, a grip, and a fighting butt. I don't do that kind of work any more, but it should not too hard to figure out. Good Luck, and let us know what you end-up with please. Tight Wraps & Tighter Lines. Bob, New Bern, NC. Re: Detachable fighting butt components for bamboo rod?
Posted by:
Steve Chontos
(---.delta.com)
Date: November 30, 2021 04:29AM
Alex, Being a Machinist I love a challenge like this. You should be able to build what you want off of something like a Channel Lock Ferruled Reel Seat set up from Mudhole and a fighting butt of your choice and some scrap rod blank pieces. Take a look at them and let us know.
Good Luck Re: Detachable fighting butt components for bamboo rod?
Posted by:
gary Marquardt
(---)
Date: December 09, 2021 06:36PM
Rodon used to make something similar but it was a screw in setup. There is a threaded adapter fit into the seat the then the fighting butt screwed into that. I thing I still have one or two. I’ll dig for it for pics if you need a visual. Sorry, only registered users may post in this forum.
|