SPONSORS
2024 ICRBE EXPO |
Pflueger President 30 spool diameter
Posted by:
Doug Schreiber
(---)
Date: April 10, 2020 11:32AM
Building a rod for this reel and was wondering if anybody had the spool diameter?
Thanks, Doug See you on the water, Doug Captain Paddlefoot Re: Pflueger President 30 spool diameter
Posted by:
Steven Bloomfield
(---.client.mchsi.com)
Date: April 10, 2020 02:19PM
42mm. Re: Pflueger President 30 spool diameter
Posted by:
Dan Ertz
(---)
Date: April 10, 2020 08:03PM
You can also estimate the spool dia. by using the data for line retrieved per handle revolution and reel gear ratio. Useful for comparing reels that you order (I hate small dia spools that coil the line) and for planning guide sizes when you don't have the reel in hand. Most retail sites and reel companies provide the info you need for almost any reel - if not, a couple minutes looking at different sites will provide what you need.
Example 34" per rev. Gear ratio 5:1 pie = 3.14 (34 / 5) / 3.14= 2.17 inch spool dia Re: Pflueger President 30 spool diameter
Posted by:
John DeMartini
(---)
Date: April 11, 2020 09:53AM
The spool diameter calculation is very clever. Thanks.
When talking spool diameter for spacing guides I think it is the outer rim diameter of the spool that is needed not the diameter where the line rests. Re: Pflueger President 30 spool diameter
Posted by:
Steven Bloomfield
(---.client.mchsi.com)
Date: April 11, 2020 11:55AM
John, That's where I measured my President size 30. Sorry, only registered users may post in this forum.
|