SPONSORS
2024 ICRBE EXPO |
Dan Craft Sig V 905 - 4 tip top?
Posted by:
Jason Pereira
(---.dsl.telepac.pt)
Date: April 06, 2017 05:01AM
Hi all,
I need to replace the tip top on my Dan Craft Sig V 905 - 4 and don't know what size to order, I'm still currently using the rod and will be up until the replacement arrives so hoping someone will have the answer. Best regards Jason Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
Spencer Phipps
(172.58.41.---)
Date: April 06, 2017 12:00PM
There are a couple generations of that blank, call Dan he can supply a tip top.. Haven't talked to him in a few years, at the time he was working mornings at his real job, afternoons after 3 pm PDST was best. Edited 2 time(s). Last edit at 04/06/2017 07:54PM by Spencer Phipps. Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
Matthew Pitrowski
(---.lightspeed.milwwi.sbcglobal.net)
Date: April 06, 2017 03:22PM
they are measured in 1/64 th inch the tube and ring use a caliper and you can order the tip top be it a wire looped top or a ceramic insert The best day to be alive is always tomorrow !! Think out side the box when all else fails !!! Wi. Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
eric zamora
(---.lightspeed.frsnca.sbcglobal.net)
Date: April 06, 2017 04:24PM
wait, what????? you can order a tip section? i broke my Sig V 8'-3" 4piece 3/4 weight years ago....! i loved that rod!!!!! i'm going to have to contact dan and see what he says. i thought he had told me not available years ago.
eric fresno, ca. Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: April 06, 2017 07:49PM
Maybe not Eric.
My Sig IV 9 ft.,5 piece, 5 wt. couldn't be fixed.He has had a few generations of rods, sometime with years before re-introduction, made by different manufacturers, so you could be like me with no replacement. Replaced it with a Sig V, 9 1/2 ft. 6 wt. which have very similar power and action. Edited 1 time(s). Last edit at 04/06/2017 07:56PM by Spencer Phipps. Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: April 07, 2017 10:24PM
Eric...."tip top" not tip section. Re: Dan Craft Sig V 905 - 4 tip top?
Posted by:
Jason Pereira
(---.dsl.telepac.pt)
Date: April 08, 2017 03:46AM
Yep defo Tip Top not top section - I emailed Dan and received an instant reply, for future reference it's a 4.5
Have a great weekend everyone :) Sorry, only registered users may post in this forum.
|