SPONSORS
2024 ICRBE EXPO |
About reel seats
Posted by:
Pekka Kemppainen
(---.ip1.netikka.fi)
Date: January 28, 2014 12:57AM
Hi!
I'm collecting parts for my 1st rod and i'm wondering about reel seat outside diameters. Seat are Pac Bay's Minima casting version: [www.mudhole.com] and Fuji's SK2 [www.mudhole.com] Does rear grips for Fuji fit straight to minima? Like this one: [www.mudhole.com] Thanks -Pekka Re: About reel seats
Posted by:
Todd R. Vivian
(---.se.biz.rr.com)
Date: January 28, 2014 04:47PM
Pekka,
not without some slight modification. Regards, Todd Regards, Todd Vivian Mud Hole Custom Tackle todd@mudhole.com Re: About reel seats
Posted by:
Pekka Kemppainen
(---.elisa-mobile.fi)
Date: January 28, 2014 05:01PM
Ok.
Does fuji and minima have same o.d.? Does aluminium locking nut fit to minima, or should i use fuji 's threaded barrel for SK seats? [www.mudhole.com] -Pekka Re: About reel seats
Posted by:
robert kravic
(---.pools.spcsdns.net)
Date: January 29, 2014 09:53AM
pekka- i would worry more about getting the right I.D. get one a little smaller than the spot on your blank where it will be installed then ream it to fit. although i haven't used one yet the minima should come with everything you need, just don't forget to cut some threads off of the locknut barrel as it will feel better in your hand. remember sandpaper is your friend for your outside diameters either the handle or the trigger itself. hope this helps Sorry, only registered users may post in this forum.
|