SPONSORS
2024 ICRBE EXPO |
Thread color on Bass Pro rod
Posted by:
Wes Phelan
(50.44.45.---)
Date: July 26, 2013 09:09PM
I have been lurking for some time, and I have learned a lot from this site.
I have two Carbonlite rods to repair. I am unable to determine what thread was used on the early Carbonlite rods. I can match the trim colors, but not the main wrap. I'm pretty sure it is a metallic thread, and it looks like a dirty copper or a mocha. Does anyone know of a good match? Thanks in advance. Re: Thread color on Bass Pro rod
Posted by:
Hal Lambert
(---.flo.bellsouth.net)
Date: July 26, 2013 09:22PM
If I am not mistaken it is pewter. Don't know if iris still made but I picked up several discontinued spools a few years ago. I believe it was fishhawk.
Maybe try the pro wrap pewter 9810. Edited 1 time(s). Last edit at 07/26/2013 09:25PM by Hal Lambert. Re: Thread color on Bass Pro rod
Posted by:
Wes Phelan
(50.44.45.---)
Date: July 26, 2013 09:47PM
I'm holding a Pro Qualifier and a Carbonlite side by side under a bright light. The main wraps look the same color. Looking at an undisturbed wrap (through the epoxy) they look yellowish/greenish/brown. Where the guide is missing and the thread is hanging bare they do in fact look like pewter.
Thanks for the reply. Re: Thread color on Bass Pro rod
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: July 27, 2013 10:26AM
If you can take a guide off Try to keep the thread in as large a section as you can
The underside should tell you very close to the color I then try to match it to a thread color chart If two or three seem to match get them Then put them on some scrap and coat to be sure I would Guess they did not use CP ??? Bill - willierods.com Re: Thread color on Bass Pro rod
Posted by:
Wes Phelan
(50.44.45.---)
Date: July 27, 2013 10:55AM
That is good advice. I can take about half of one wrap off intact, so it should be easy enough to match it to one of the online sites color chart. Thanks. Re: Thread color on Bass Pro rod
Posted by:
bob welty
(63.77.139.---)
Date: August 01, 2013 04:51PM
the bps repair shop uses pewter thread for repairs on the carbonlites and most of the pro qualifiers Re: Thread color on Bass Pro rod
Posted by:
Wes Phelan
(50.44.45.---)
Date: August 01, 2013 07:24PM
Thanks. I have some ordered. Sorry, only registered users may post in this forum.
|