SPONSORS
2024 ICRBE EXPO |
>>>> Just Checking >>>>
Posted by:
Donald Newenhouse
(---.dhcp.embarqhsd.net)
Date: May 26, 2013 05:36PM
Doing a new build, just opened a new container of U- 40 Rod bond Resin . It appears to be some what crystalized and not as smooth as my last container . Is it ok to use, or will I run into a problem with it ??? The build will be going to Arlington Va. and don't want a recall . Thanks in advance for all replies . <<<<<DON>>>>> <<<<DON>>>> Fort Myers Fla. Re: >>>> Just Checking >>>>
Posted by:
Tom Kirkman
(Moderator)
Date: May 26, 2013 05:53PM
It's fine. Take lid off and pop it in the microwave for about 15 seconds. Repeat until it returns to the desired state. Or, set it in a pan of very hot water for about 10 minutes.
.................... Re: >>>> Just Checking >>>>
Posted by:
Donald Newenhouse
(---.dhcp.embarqhsd.net)
Date: May 26, 2013 08:59PM
Thank you Tom, shall pop it in the mic as you suggested .. "Happy Holiday" Re: >>>> Just Checking >>>>
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: May 27, 2013 01:46AM
Donald,
When you use the microwave, just hit it with 10 seconds burst of juice. For some of these materials, it takes a surprisingly short amount of time to get the material ready. You want to be sure not to COOK the material. As Mr. Kirkman suggested - a nominal 15 seconds is about right - but it is dependent on the size of the container of finish. Re: >>>> Just Checking >>>>
Posted by:
ray balmforth
(101.161.30.---)
Date: May 27, 2013 06:19AM
G'day Donald
Not sure whats going on with the Trondak resin but i got my second pot and it was the same. But as has been suggested just pop it in the micro wave for 10 to 15 secs or just place the container in some warm water while your preparing to get ready.Same thing happened with my epoxy resin but no worries after i worked out the cause. cheers Re: >>>> Just Checking >>>>
Posted by:
jon edwards
(---.lightspeed.wpbhfl.sbcglobal.net)
Date: May 27, 2013 09:35PM
mine was the same after about 5 years of not using and i did the microwave thing they suggested to me also and it worked out great....i put some on a piece of card board also to see how it did and worked great still Sorry, only registered users may post in this forum.
|