SPONSORS
2024 ICRBE EXPO |
replacement rod
Posted by:
Bill Hartlage
(---.sip.sdf.bellsouth.net)
Date: March 24, 2013 06:41AM
I broke my favorite rod a 9'6" rod made by Dan Craft and is no longer available. would like a 9'6" or 10 ft 6 wt of medium fast action to build. looking at st. croix or rainshadow. any comments or suggestions appreciated.thanks Re: replacement rod
Posted by:
Bill Hickey
(---.nys.biz.rr.com)
Date: March 24, 2013 02:13PM
Check out the CTS Affinity X or Affinity MX, I would go with the Affinity X if you are going over 9ft in length. I have a pair of 5 and 6wt Affinity X's that are just awesome for nymphing rods. I also own a Dan Craft Sig V 9'-6" 6wt and it is very similar to my Affinity X's, but I would say the Affinity X is a bit (not much) faster action. Re: replacement rod
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: March 24, 2013 05:36PM
You cannot go wrong with the Batson Rainshadow. Re: replacement rod
Posted by:
Randolph Ruwe
(---.hsd1.wa.comcast.net)
Date: March 24, 2013 05:40PM
Who made the blank? Re: replacement rod
Posted by:
Spencer Phipps
(---.war.clearwire-wmx.net)
Date: March 26, 2013 10:06PM
Bill,
Tell me it's not the SigV 4 piece that's gone? Re: replacement rod
Posted by:
Bill Hartlage
(---.sip.sdf.bellsouth.net)
Date: March 27, 2013 05:52AM
believe it was an earlier IV by Dan Craft. nice rod and hope to replace tip section. I do not know who makes Dan Craft rods but they are great and the service is also. Sorry, only registered users may post in this forum.
|