SPONSORS
2024 ICRBE EXPO |
CCS Data
Posted by:
Bob Riggins
(---.se.biz.rr.com)
Date: June 04, 2012 09:23AM
Does anyone have access to the CCS data that was on the CCS Data site. That was a lot of good information and I used it extensively when designing builds. Now it seems to be gone. Re: CCS Data
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: June 04, 2012 10:09AM
The link to the data site from the CCS page has a malware warning. I did not proceed to the data site because of this, but there is a link to the data site from the CCS info page on the left. Proceed at your own risk. I'm not sure who is maintaining this but looks like it needs some virus intervention.
Terry Re: CCS Data
Posted by:
Greg LaPolla
(---.dsl.irvnca.pacbell.net)
Date: June 04, 2012 09:14PM
If you unblock youer email address I can email you the excel spreadsheet.
Greg Re: CCS Data
Posted by:
Ron Jack
(---.ngn.east.myfairpoint.net)
Date: June 05, 2012 09:20AM
Greg, Could you e mail me a copy also.
Thank you, Re: CCS Data
Posted by:
Bob Riggins
(---.se.biz.rr.com)
Date: June 05, 2012 10:34AM
E-mail is unblocked. Thanks.
It would be nice is someone stepped forward and maintained the CCS data site. It is an invaluable resource. Unfortunately, I don't have the expertise or time to do it. Re: CCS Data
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: June 06, 2012 09:21AM
I have been searching for on-line info for the URRS (casting and spinning version of the CCS) for DAYS and short of the single back issue of Rodmaker where the article originally appeared I can find very little. We need a step-by-step on the ERN, TP, and PR of a given spinning or casting blank (or rod). Anyone know if this exists??? Re: CCS Data
Posted by:
Tom Kirkman
(Moderator)
Date: June 06, 2012 09:51AM
It's the same for any type blank, fly, casting or spinning. A blank is a blank.
............. Re: CCS Data
Posted by:
Bob Riggins
(---.se.biz.rr.com)
Date: June 06, 2012 02:29PM
I just tried the link to the data page and it seems to be working. Go to the CCS information page and there is a link on the lower left hand side of the page that says CCS Data. This link seem to work. It also includes some spinning and casting rod data. Sorry, only registered users may post in this forum.
|