SPONSORS
2024 ICRBE EXPO |
Sizing Reel Seat and Cork Grip
Posted by:
dave pritchard
(---.hsd1.ma.comcast.net)
Date: April 27, 2012 07:20AM
I am in the beginning stages of rebuilding a bamboo rod that I recently picked up. The cork grip was chewed up - probably mice. So first, how best to remove the grip and reel seat and then how do I size them so I can purchase new grip and reel seat.
On the winding, as this is a vintage rod, probably from the 30's, what size thread and what type thread should I use? Oh, one more question - for the tip I see large loop and small loop - which one for this rod? Thanks, Dave Re: Sizing Reel Seat and Cork Grip
Posted by:
Peter Appel
(---.blrgga.dsl.dynamic.tds.net)
Date: April 28, 2012 10:03AM
Dave,
What kind of rod is this? From your comment about the tips, I'm assuming it's a fly rod. The cork grip should be pretty easy to get off in any event - it's probably pretty brittle, so you can cut it off with a sharp knife. I would make an outline/dimensional sketch of the grip before you cut it, so you can reproduce it accurately. Reel seat removal somewhat depends on the rod type. Many rods have small pins through the reel seat barrel to lock the seat on, and they can be a challenge to find and drive out. When you've removed the pin ( a small nail of appropriate diameter with the tip filed flat makes a good drift punch), the reel seat is typically glued onto a wooden arbor with a thermosetting glue. Heating the seat will allow you to twist it off. Thread size depends on the rod type - fly rods typically used size A or 3/0 silk. Save some of the thread when you strip the guides, so you can match what's on it - the color on the inside of the thread next to the blank will give you the most accurate indication of the original color(s). Again, make notes and drawings of wrap style, length and guide placement before you strip it. Tip loops were typically small loops for silk lines, which are smaller in diameter for a given weight than modern synthetic lines. Some of your decisions will be governed by the intended use for the rod - is it going to be restored as a wall hanger, or are you planning to use it ? Are all the sections the same length? If not, you may want to consider having the short sections repaired, which is best left to a specialist. Re: Sizing Reel Seat and Cork Grip
Posted by:
dave pritchard
(---.hsd1.ma.comcast.net)
Date: April 28, 2012 05:07PM
Totally spaced it on the rod type - sorry it's a fly rod - which, by the way, I'm restoring for my Grandson to eventually use.
So,as I'll have him casting regular line, does that mean I go with the large loop tip? Thanks Re: Sizing Reel Seat and Cork Grip
Posted by:
Peter Appel
(---.blrgga.dsl.dynamic.tds.net)
Date: April 29, 2012 09:52AM
Dave,
I would suggest using the larger loop top, replacing and increasing the number of guides and rewrapping with nylon, rather than silk thread. Do a careful inspection of the cane to make sure there are no delamination or crack issues. Have fun! Sorry, only registered users may post in this forum.
|