SPONSORS
2024 ICRBE EXPO |
fuji sk butt question
Posted by:
john backos
(---.design2147.com)
Date: April 20, 2012 07:38AM
How does one mount the butt grip on the end of the rod. The bore doesn't go through. Is it as simple as just reaming it out? Re: fuji sk butt question
Posted by:
David Stanfield
(---.knology.net)
Date: April 20, 2012 08:38AM
That's what I have done on approximately 6 builds. I did shape the edge of the butt and added an SK2 winding check for appearance. No problems. Re: fuji sk butt question
Posted by:
Chuck Howard
(---.carolina.res.rr.com)
Date: April 20, 2012 08:39AM
Yes John, just go slow if you’re using a regular drill bit-one step at a time. When you get close to the right size wrap a piece of sand paper on the end of the last bit you used and sand it open to size. If you need it larger, wrap a piece of masking tape on the bit and sand a little more-repeat by adding more tape as needed.
Chuck Re: fuji sk butt question
Posted by:
john backos
(---.design2147.com)
Date: April 20, 2012 03:22PM
Thanks for the responses. The solution is almost too obvious. Re: fuji sk butt question
Posted by:
Ryan Higgins
(---.142.223.19.nwinternet.com)
Date: April 20, 2012 05:39PM
Yup I'll be reaming it out and putting a winding check on the top to cover. Sorry, only registered users may post in this forum.
|