SPONSORS
2024 ICRBE EXPO |
Fisheye/Removal?
Posted by:
Bruce Tomaselli
(---.altnpa.east.verizon.net)
Date: September 28, 2011 06:16PM
Guys, can you sand off fisheyes from the finish? Re: Fisheye/Removal?
Posted by:
Ron Weber
(---.ph.ph.cox.net)
Date: September 28, 2011 08:43PM
Sure can, dont know if this link will work, but I will give it a try Not just for fisheyes, but also fuzzies
[www.rodbuildingforum.com] Re: Fisheye/Removal?
Posted by:
matthew jacobs
(---.122.31.71.static.ip.windstream.net)
Date: September 29, 2011 08:28AM
Yes sir, I just had to straighten a rod of mine out. It was a tournament rod so as long as it cast an empty hook and brought back a fish, it served it's purpose.
Sand it down, wipe it clean and then refinish it, you'll never know the difference. Re: Fisheye/Removal?
Posted by:
JIM MOWL
(---.stat.centurytel.net)
Date: September 30, 2011 03:01PM
You shouldn't have to "sand it off". Scuff the wrap and makes sure you get down into the fisheye. If you try to sand all the epoxy down to the level of the bottom of the eye you risk hitting thread. Just scuff good, wipe with DNA and recoat, the additional coat will fill the eye. Sorry, only registered users may post in this forum.
|