SPONSORS
2024 ICRBE EXPO |
Vibronic Rods
Posted by:
Ray Mazza
(---.syrcny.east.verizon.net)
Date: June 20, 2011 09:47AM
In my post last week, I said I'm making some casting bubble rods with graphite TN handles. Over the weekend I was flipping through my collection of RodMaker Magazines and re-read the Vibronic Rod article. Seems like a good idea for the bubble rods. The article didn't go into detail as to how the handle is attached to the blank on the spinning rod, or what material is used to cap the ends. I have a couple of ideas, but thought I'd see what others have tried before I build. Thanks for sharing.
Ray Mazza Midstream Rods Utica, NY Re: Vibronic Rods
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: June 20, 2011 02:43PM
Hello Ray.
Talk to Steve Gardner it's his "Thing".(super light stuff). Bob, New Bern, NC. Re: Vibronic Rods
Posted by:
Phil Ewanicki
(---.135.188.72.cfl.res.rr.com)
Date: June 22, 2011 09:29AM
By any chance are these rods manufactured at the Gizmonic Institute? Re: Vibronic Rods
Posted by:
Ray Mazza
(---.syrcny.east.verizon.net)
Date: June 23, 2011 06:55PM
Sent him an email. Hoping to hear back. Sorry, only registered users may post in this forum.
|