Have decided to try a dc motor for my rod drier so have gotten hold of one from @#$%&.
It arrived today but noticed the 2 spade end connectors on the motor are really small, say 1.7mm wide and 0.4 thick. Do any of you guys know where I can get hold of some female connectors that will fit this motor?
Philip

A good hardware store should have them in the electrical section.

_________________________________________
"Angling is extremely time consuming.
That's sort of the whole point." - Thomas McGuane

I soldered directly to the terminals, Easy! then attached the wire to the motor body with a zip tie,so there is no strain on the wiring

Do you have a Radio Shack store near you? They sell those tiny connectors. You could just cut them off and twist your wires and tape them or use some shrink tube.Barry has the right idea in tying the wires up so there is no strain on them.

Thanks Guys,
Unfortunately we dont have a radio shack shop over here in the uk.
Do you mhave a web site I can maybe contact them to supply me some?

Philip

Hi, Phil,
www.radioshack.com

"It ain't what you don't know that gets you into trouble.It's what you know for sure that just ain't so." Mark Twain
John in Wethersfield, CT

Thanks John,
Have replied to your e-mail.
Phil