SPONSORS
2024 ICRBE EXPO |
Dimension for Adjustable rod support clamp
Posted by:
Bill Giokas
(---.bos-dynamic.gis.net)
Date: November 08, 2010 06:16AM
Can someone give me the dimensions for the lower clamp on the adjustable rod support clamp that is used on the Pac Bay /American Tackle wrappers? It looks like form the photo that the lower clamp is removable. Thanks Bill Re: Dimension for Adjustable rod support clamp
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: November 08, 2010 08:47AM
Bill,
Use a tape measure and straight edge to determine the necessary dimensions. Good luck Roger Re: Dimension for Adjustable rod support clamp
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: November 08, 2010 08:47AM
Bill,
Remember, if you are talking about the lower rod support clamp, you need to have a range of adjustment in the clamp to allow for the use of various blanks - if this is the support clamp of which you are speaking. Roger Re: Dimension for Adjustable rod support clamp
Posted by:
wayne diduch
(---.cpe.net.cable.rogers.com)
Date: November 08, 2010 05:32PM
Bill, the Lower Clamp [ Vertical ] support is 1/16'' Flat Bar 3 3/16" High, 1 3/8" Wide. the slot in the bracket is 1/4" Wide and 1" High [ vertical travel of slot ] . The end of the 1/4" x 1 " slot starts at 11/16"of an inch from the Bottom of the vertical Bar. Hope this makes sense Cheers....Wayne Re: Dimension for Adjustable rod support clamp
Posted by:
Bill Giokas
(---.bos-dynamic.gis.net)
Date: November 09, 2010 05:11AM
Thanks Wayne. I might uses these brackets on my Grizzly Hobby lathe. Bill Re: Dimension for Adjustable rod support clamp
Posted by:
wayne diduch
(---.cpe.net.cable.rogers.com)
Date: November 09, 2010 04:05PM
Bill, my pleasure, glad i could help!! Wayne Sorry, only registered users may post in this forum.
|