SPONSORS
2024 ICRBE EXPO |
Help with trim wrap
Posted by:
Mike Bradford
(---.war.clearwire-wmx.net)
Date: October 16, 2010 08:21PM
I just uploaded 2 pictures to the guide wrap picture page. I am doing a rod with Metalic Black, and Cardenal Red thread. I can't figure out how to get the black trim to look like it is one complete wrap. I either wind up with an overlap, or a blank space. I did both of these wraps, and they were perfect before I started burnishing and packing. The pictures are at: [www.rodbuilding.org] . The second is at: [www.rodbuilding.org] .
Any help with fixing this problem would be greatly appreciated. Mike Bradfrod R.M.B. Fishing Rods Nampa, Idaho Re: Help with trim wrap
Posted by:
Michael Blomme
(---.spkn.qwest.net)
Date: October 16, 2010 09:58PM
Hi Mike,
If you go to the top of this window, you will find a "Button" that says Library. If you click on that you will find a series of articles. One is called "NarrowTrim Bands and Inlays by Tom Kirkman. This article provides complete directions with photos showing how to make your trim bands. Have fun, Mike Blomme Re: Help with trim wrap
Posted by:
Matt Ekhaml
(---.lv.lv.cox.net)
Date: October 16, 2010 09:59PM
The trim band might not be tight enough. Those pics are kinda small to see the fine detail... Re: Help with trim wrap
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: October 17, 2010 12:37PM
Mike,
Could you do me a favor and mail be a large picture of your wraps? hflier@comcast.net With a larger picture, I may be able to offer a couple of suggestions. Also, if you could send two or three pictures of the wrap as you are doing it would be helpful as well. Roger Sorry, only registered users may post in this forum.
|