SPONSORS
2024 ICRBE EXPO |
.875 EVA Butt Caps
Posted by:
Jeff Mahnken
(---.supptctr.clemson.edu)
Date: August 05, 2010 09:27AM
I have been looking for some EVA butt caps with an id of .875 for some handles that I picked up at ICRBE. Most handles came with caps but a few didn't, anyone know of a source? Thanks in Advance! Lucky J's custom rods Re: .875 EVA Butt Caps
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: August 05, 2010 10:16AM Re: .875 EVA Butt Caps
Posted by:
Jeff Mahnken
(---.supptctr.clemson.edu)
Date: August 05, 2010 11:06AM
YES I saw those but I want EVA not Rubber or vinyl. Thanks anyway. Lucky J's custom rods Re: .875 EVA Butt Caps
Posted by:
BobMcKamey
(---.se.biz.rr.com)
Date: August 05, 2010 11:17AM
Jeff -- Just as a idea. If the grips have a recessed tenon on the end, you can cut that off and then build up the end of the rod blank with mesh tape or a graphite arbor to accomodate the inside of a particular EVA butt cap that you like. If I went that direction, I would just make sure the outside of the butt cap purchased was close or matches the outside diameter of the grip being used. Bob McKamey bobm@mudhole.com Re: .875 EVA Butt Caps
Posted by:
Jeff Mahnken
(---.supptctr.clemson.edu)
Date: August 05, 2010 01:15PM
Here is what I am looking for [www.rodbuilding.org]. I like the bigger size on tenon when fitting the cork to bigger rod blanks. also would like to use on some carbon fiber grips that I am making. Lucky J's custom rods Re: .875 EVA Butt Caps
Posted by:
BobMcKamey
(---.se.biz.rr.com)
Date: August 05, 2010 01:30PM
Jeff -- That is our part number ECC 22 at Mud Hole. I just went and checked the I.D. of the ECC 22 and what we have listed on our web-site and catalog of the 1" I.D. is not correct. The cap has the inside diameter you are needing. Bob McKamey bobm@mudhole.com Edited 1 time(s). Last edit at 08/05/2010 01:41PM by Bob McKamey. Re: .875 EVA Butt Caps
Posted by:
Jeff Mahnken
(---.supptctr.clemson.edu)
Date: August 05, 2010 01:53PM
Good to know. Well I did buy some of the handles from you guys at ICRBE but you didn't have any caps with the handles. Thanks I will be making an order soon. Lucky J's custom rods Sorry, only registered users may post in this forum.
|