SPONSORS
2024 ICRBE EXPO |
guide for PBShop Rick Clunn series rod
Posted by:
Mark Marshall
(---.dhcp.jcsn.tn.charter.com)
Date: May 26, 2010 08:10PM
I have a customer needing a casting guide for a Rick Clunn Signature Series rod. The guides are Fiji. Cannot tell the type of ring. The guides are a spin/cast type guide. This was not an expensive rod when purchased. Around $100.
Any ideas would be appreciated! Re: guide for PBShop Rick Clunn series rod
Posted by:
Andy Jones
(---.gsp.bellsouth.net)
Date: May 26, 2010 09:30PM
As hard as it is to believe for a $100 rod the Rick Clunn rods have Gunmetal Fuji SIC guides on them. Which size do you need? I have a 3/4's of a set I stripped off a rod that I will not use I will send you the size you need . Re: guide for PBShop Rick Clunn series rod
Posted by:
Mark Marshall
(---.dhcp.jcsn.tn.charter.com)
Date: May 26, 2010 09:48PM
Andy
Thanks, it is gunmetal. I thought it might be SIC but not on a medium priced rod. I will post the size tomorrow. Please check back on the forum. Thanks Mark Re: guide for PBShop Rick Clunn series rod
Posted by:
Bob Grobolsek
(---.dyn.centurytel.net)
Date: May 27, 2010 07:03AM
On another similar note. I have to replace one of the guides as well, and was wondering if anyone had an idea of the thread color used on this rod. It is a dark purple with a metallic blue trim. Thanks. Bob Grobolsek Sheffield Village, Ohio Sorry, only registered users may post in this forum.
|