SPONSORS
2024 ICRBE EXPO |
RodMaker 12-6 Cover Photo Question
Posted by:
Dan Ertz
(---.dsl.airstreamcomm.net)
Date: January 02, 2010 12:25PM
Saw the photo of the cover in the photo gallery and that's a sharp looking rod!
I'm curious about the reel seat. Am I correct that this is a "NSP" seat that's been modified? In addition to the porting on the sides, it looks like the area where the reel foot is normally seated has been machined out so that the reel rests directly on the rod blank? If so, how has the locking ring been modified to secure the reel? Thanks. Dan Re: RodMaker 12-6 Cover Photo Question
Posted by:
Tom Kirkman
(Moderator)
Date: January 03, 2010 03:54PM
The seat has been "ported" mostly for looks but it does lighten a seat quite a bit to put a half dozen 3/8th inch holes in it.
Nothing else was done except for a 1/2 inch shortening of the threaded barrel. ......... Re: RodMaker 12-6 Cover Photo Question
Posted by:
Dan Ertz
(---.dsl.airstreamcomm.net)
Date: January 03, 2010 04:30PM
Thank you Tom. Sorry, only registered users may post in this forum.
|