SPONSORS
2024 ICRBE EXPO |
epoxy finish layers
Posted by:
jeroen teugels
(---.access.telenet.be)
Date: November 01, 2009 04:35PM
Hi,
I'm building a rod for myself and I put 2 very thin coats of flexcoat ultra V (high build) over the st-croix decal. I'd like to put a third thin coat over it but it was almost a month ago since the second coat... I previously never waited more then 24 hours between coats... In other words...can you put another coat of epoxy over one that is allready fully hardened? I'm a bit afraid it will crack after some time... thank you in advance! greetz, Jeroen Belgium Re: epoxy finish layers
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: November 01, 2009 05:21PM
Scuff the area to knock off the shine and add another coat without worry!
DR Re: epoxy finish layers
Posted by:
Tom Kirkman
(Moderator)
Date: November 01, 2009 05:52PM
Right, clean the area with water or alcohol and then use Scotchbrite to scuff and degloss the previous coat and then apply the new epoxy (don't wipe with a solvent after you scuff the area, just dust it off).
................ Re: epoxy finish layers
Posted by:
jeroen teugels
(---.access.telenet.be)
Date: November 01, 2009 07:23PM
OK! Great!
thank you very much for the help! greetz, Jeroen Sorry, only registered users may post in this forum.
|