SPONSORS
2024 ICRBE EXPO |
Tip section for rebuild
Posted by:
Steve Cox
(---.client.mchsi.com)
Date: August 06, 2009 01:22PM
I have a butt section of a 2 pc , 9' fly rod. Not certain what make it is. Is there any place out there where you can get a matching tip section simply based on ferrule fit? Re: Tip section for rebuild
Posted by:
Tom Kirkman
(Moderator)
Date: August 06, 2009 02:24PM
Matching? No.
You can probably find something that will fit, but it won't likely match in terms of being a continuation of the butt section's power and action. I suspect it would be a wasted effort considering what you'd wind up with. ........ Re: Tip section for rebuild
Posted by:
William Bartlett
(---.br1.dav.wv.frontiernet.net)
Date: August 07, 2009 02:23PM
If you know who the manufacturer is of the blank in the butt section, you may be able to contact them, and come close. If it's an obscure blank, then your pretty much locked into try it and see, if possible. Or just build a new rod. Bill in WV Sorry, only registered users may post in this forum.
|