SPONSORS
2024 ICRBE EXPO |
ONE PEICE TWO PEICE ?????????????
Posted by:
joseph p sanchez
(---.sub-75-208-84.myvzw.com)
Date: May 06, 2009 12:04AM
???????? IS it possible,to turn a one piece rod ninto a Two piece..... Re: ONE PEICE TWO PEICE ?????????????
Posted by:
Phil Brenner
(198.217.64.---)
Date: May 06, 2009 02:05AM
Yes, i just did it today. I closed my toolbox on one of my loomis rods. instant 2 piece. LOL Im sure that you can add ferrules after cutting, but i have never done this and cant offer any advice. somebody here will walk you through it though im sure. Re: ONE PEICE TWO PEICE ?????????????
Posted by:
Robert Balcombe
(---.rb.gh.centurytel.net)
Date: May 06, 2009 02:51AM
Go to the Library and look up broken rod repair by Ralph OQuinn. the principle is the same Good Wraps Bob Re: ONE PEICE TWO PEICE ?????????????
Posted by:
Bobby Bolivia
(---.nwrknj.east.verizon.net)
Date: May 06, 2009 06:27AM
The process is called an oversleeve. I guess you can google that or search here if you needed more that whats in the lib. Re: ONE PEICE TWO PEICE ?????????????
Posted by:
Tom Kirkman
(Moderator)
Date: May 06, 2009 08:18AM
That information was contained in RodMaker Magazine some time ago. I'd have to go back and look up the volume and issue number. It can certainly be done very well and very effectively. But it requires careful planning and operation on your part.
.............. Re: ONE PEICE TWO PEICE ?????????????
Posted by:
Ken Finch
(---.orlando-03rh16rt-04rh15rt.fl.dial-access.att.net)
Date: May 06, 2009 09:24AM
Yes you can do it! You can also just buy a two piece model and save yourself the trouble. If you are just starting out I think I would say to just buy a two piece and be done with it. Re: ONE PEICE TWO PEICE ?????????????
Posted by:
joseph p sanchez
(---.sub-75-210-133.myvzw.com)
Date: May 07, 2009 12:04AM
THANK YOU, this helps I think i will go with phils idea and use my car door. no thankyou this helps i wil look it up ... Sorry, only registered users may post in this forum.
|