SPONSORS
2024 ICRBE EXPO |
Looking for Flex Coat 1 oz. pumps
Posted by:
Marc Morrone
(---.dsl.airstreamcomm.net)
Date: December 28, 2008 08:47PM
Just wondering if any vendors stock the Flex Coat 1 oz. pumps, I'd like to use them for my FC glue.
Thanks, Marc Re: Looking for Flex Coat 1 oz. pumps
Posted by:
Chris Davis
(---.knology.net)
Date: December 28, 2008 09:27PM
Marc-
Something else you might try if you haven't-I use syringes in the tops of my liquid epoxy bottles-like used for rod finish. Clean and accurate-just cut off yorker caps that come on most at a point where the syringe tip fits. Larger syringes can be used if mixing larger amounts. Only way I've found to mix accurate amounts so as to get a cure rate that matches what manufacturers say-a little too much or too little hardner and rate changes significantly. Chris Re: Looking for Flex Coat 1 oz. pumps
Posted by:
Robert Gilbertson
(---.dialup.fsr.net)
Date: December 28, 2008 10:32PM
Anglers Workshop has 1/2 cc pumps that fit 2, 4, and 16 oz. bottles in their catalog. Re: Looking for Flex Coat 1 oz. pumps
Posted by:
john cocoplum
(---.hsd1.fl.comcast.net)
Date: December 28, 2008 10:33PM
custom tackle supply Re: Looking for Flex Coat 1 oz. pumps
Posted by:
Ron Schneider
(---.mthmcmta01.mthoar.lr.dh.suddenlink.net)
Date: December 29, 2008 11:48AM
Marc,
If you mean the large pumps that measure 10 1/2" from the bottom of the cap to the end of the tube and actually pump 1 full OZ per stroke, we have a set in stock. We'll be here for just part of the week and then heading for Collinsville, IL for s Sports Show the end of this week. Give us a holler toll-free at 1-888-946-2427 Best wishes, Ron Schneider Schneider's Rod Shop Mountain Home, Arkansas [www.schneidersrods.com] mtnron40@yahoo.com 870-424-3381 Sorry, only registered users may post in this forum.
|