SPONSORS
2024 ICRBE EXPO |
Threadless guide wraps
Posted by:
Marco Cellini
(---.cust.tele2.it)
Date: June 08, 2008 06:21PM
I'm going to build my first sensi-touch custom rods follow the article by Bill Stevens. Now I have the Perma Gloss to start the work but I haven't the Swifty Rod Finish epoxy suggest into the article to fix the guide on the blank before use the PG for topcoat.
Does anyone can suggest me what kind of epoxy or glue I can use instead of Swifty above to have a good job? Thanks in advance Re: Threadless guide wraps
Posted by:
Bill Stevens
(---.br.br.cox.net)
Date: June 08, 2008 07:45PM
Marco I would suggest that you use a tiny tiny tiny spec of Rod Bond Five Minute Epoxy Paste or the Threadmaster Ultimate Gel for the initial attachment. Just use enough inside the tunnel and then fine tune the alignment before cutting the bands. If this is not available a small amount of gelled Super Glue will to the trick. Re: Threadless guide wraps
Posted by:
Marco Cellini
(---.ip.fastwebnet.it)
Date: June 09, 2008 04:29AM
Bill, thanks a lot for you help, I'm certain that everythings will works fine ! Sorry, only registered users may post in this forum.
|