SPONSORS
2024 ICRBE EXPO |
Do you know a good plater?
Posted by:
Ash Carlton
(---.cpm.net)
Date: August 03, 2007 12:26PM
I'm looking to get some old ferrules and various other hardware refinished for an old Montague boat rod. It seems as though no one around me does nickel silver plating. I need the ferrules striped of the current plating and then replated. Unless someone know of NOS Montague ferrules for a boat rod NOT a fly rod. Re: Do you know a good plater?
Posted by:
LARRY PIRRONE
(---.att.net)
Date: August 03, 2007 01:43PM
I think jeff fultz may do it. fultz rod company. i know he was plating ferrules to re-fit them. Re: Do you know a good plater?
Posted by:
Marc Morrone
(---.dsl.airstreamcomm.net)
Date: August 03, 2007 01:43PM
I used to work with a plater called Hydro-Platers in Milwaukee, WI. They did electroless nickle, and a variety of other platings. They were able to polish some of our product to Ra 8 or better - which is like glass - after plating. I don't have their number at my finger tips, but they are listed. Worked with a very nice guy there named Hoy.
Good luck, Marc Re: Do you know a good plater?
Posted by:
Dave Hauser
(---.hsd1.ca.comcast.net)
Date: August 03, 2007 02:27PM
Poke around with the car restoration, bike builders, or gunsmith niches. Especially the gun niches, as they do a lot of ickle plating still. Re: Do you know a good plater?
Posted by:
Fred Halfheimers
(---.milwpc.com)
Date: August 04, 2007 06:26AM
Dave LeClair does a lot of it. Here is his web site,, good luck,,, a lot of the bamboo restorer use him.
[www.flyandrodroom.com] Sorry, only registered users may post in this forum.
|