SPONSORS
2024 ICRBE EXPO |
rod coating came off
Posted by:
Ken Blevins
(---.ironoh.adelphia.net)
Date: December 10, 2005 01:09PM
As I was repositioning a guide this morning I removed some of the shiny material on the blank. After picking and rubbing around on it I now have about a 2 inch area on the blank with no color, just exposed graphite .what do I need to do to correct this problem ? Will covering the area with a thin layer of epoxy do the trick .I’m open to suggestions ….
Thanks a lot Ken Blevins Re: rod coating came off
Posted by:
Scott VanGuilder
(---.client.mchsi.com)
Date: December 11, 2005 07:38AM
I would send it back, sounds defective to me. The finish is usually like paint or varnish so if it is coming off I would think that is probably not the only spot. Re: rod coating came off
Posted by:
Bill Ewing
(---.hvc.res.rr.com)
Date: December 13, 2005 10:36AM
I would have to agree see if the manufacturer will
exchange the blank . Its possible that the coating that was put on the blank was incorrectly formulated and your problem is the end result. Tightlines. Sorry, only registered users may post in this forum.
|