SPONSORS
2024 ICRBE EXPO |
Power Wrapper Question.
Posted by:
Al McClure
(---.vf.shawcable.net)
Date: April 18, 2005 10:45PM
Which make of power wrapper can be used to turn cork grips? Re: Power Wrapper Question.
Posted by:
Robert crabtree
(---.proxy.aol.com)
Date: April 19, 2005 01:25AM
renzetti or pac-bay will do ya good if you wanna spend the money i prefer i use a drill lathe setup mysely and i found this works good just my opinion hope i could help............ Re: Power Wrapper Question.
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: April 21, 2005 10:59AM
Al,
If you want a great cork set up for about $75 (including drill), check out the Grizzly Hobby Lathe. Strong, portable and very popular with rod builders for working cork/EVA. If you plan on going into wood, you might want to look into a Penn State Turncrafter Pro or Jet mini lathe. Mike [www.rodbuilding.org] Sorry, only registered users may post in this forum.
|