SPONSORS
2024 ICRBE EXPO |
Nuking Rod Bond
Posted by:
Joel Todd
(---.nas32.chicago3.il.us.da.qwest.net)
Date: March 25, 2005 08:45AM
Is it safe to nuke the Rod Bond resin in the microwave for a little bit.Mine is somewhat harder than it should be?Even when mixed up thoroughly I get little chunks of the resin that does'nt mix with the hardener.It sets up just fine and dries hard.Thanks Joel Re: Nuking Rod Bond
Posted by:
Anonymous User
(Moderator)
Date: March 25, 2005 08:53AM
Take the lid off and do it in short 8 to 10 second bursts. A better way might be to just sit the jar in a pan of really hot water for about 10 to 15 minutes.
............. Re: Nuking Rod Bond
Posted by:
Ralph D. Jones
(---.att.net)
Date: March 25, 2005 11:52AM
Joel, I have used the hot water method and it is safer IMO than the microwave. Ralph If at first you don't succeed, go fishing, then try, try again. Re: Nuking Rod Bond
Posted by:
Joel Todd
(---.nas32.chicago3.il.us.da.qwest.net)
Date: March 25, 2005 03:33PM
Thanks for the replies.I will give this a go next time.The ice is off Lake Erie.Next week the boat comes out of storage.Good Friday,Joel Sorry, only registered users may post in this forum.
|