SPONSORS
2024 ICRBE EXPO |
changing name on rod?
Posted by:
Richard Duncan
(---.satx.res.rr.com)
Date: March 20, 2005 10:55AM
I have a T&T factory rod that was personalized for someone else. Is it practical to remove his name and either leave it blank or put mine? Re: changing name on rod?
Posted by:
bill boettcher
(---.an3.nyc41.da.uu.net)
Date: March 20, 2005 11:16AM
If you sell it, you will have to take your name off??? Re: changing name on rod?
Posted by:
Milton (Hank) Aldridge
(---.maine.res.rr.com)
Date: March 20, 2005 12:25PM
Richard,
Possibly you could over wrap it with thread to cover the name. Hank On The Rocks Fishing Wells, ME. Re: changing name on rod?
Posted by:
Richard Duncan
(---.satx.res.rr.com)
Date: March 20, 2005 01:34PM
I'll probably keep this one for a while. If over-rapped with thread, how would you seal it to look right? Re: changing name on rod?
Posted by:
Milton (Hank) Aldridge
(---.maine.res.rr.com)
Date: March 20, 2005 08:40PM
Richard,
It's difficult to say what exactly to do without seeing the rod but maybe uses a NCP thread that matches the blanks color or regular nylon with color preserver. You could do some fancy wraps (diamonds, weave, ect) to cover it. If you keep it and it doesn't bother you just leave it. Is it a rod that you built for someone else and they did not pick it up for some reason? If it is you could use it to show customer the reason why you require deposits (been there, do that - family what can you say). Hank On The Rocks Fishing Wells, ME. Sorry, only registered users may post in this forum.
|