SPONSORS
2024 ICRBE EXPO |
Maximun distance?
Posted by:
bill boettcher
(---.250.162.113.Dial1.Weehawken1.Level3.net)
Date: March 06, 2005 11:50AM
Is there a maximun distance, of the first two or three guides before there is line slap On a spiral wrap?
Thanks guys - For casting Re: Maximun distance?
Posted by:
Anonymous User
(---.dialup.mindspring.com)
Date: March 06, 2005 02:17PM
There is a maximum but it's not fixed in stone. After taping the guides on and test casting, you may have to tweak this guide.
Ralph O'Quinn, in his writings recommended a 15 inch minimum but no maximum. Some of my surf guides are pretty far down the blank. The rule is, if there is one, is to have the transition completed prior to the flex point. I complete it prior to the lockup on the heavier rods. C2 Re: Maximun distance?
Posted by:
bill boettcher
(---.248.70.208.Dial1.Weehawken1.Level3.net)
Date: March 06, 2005 03:05PM
Thanks Charlie, I started to get nervius at 12-14" Some times you can not hear or see it if is Re: Maximun distance?
Posted by:
Kit Harrison
(---.consolidated.net)
Date: March 06, 2005 04:22PM
15" Sounds to much to me.
Kit Harrison Re: Maximun distance?
Posted by:
bill boettcher
(---.248.69.24.Dial1.Weehawken1.Level3.net)
Date: March 06, 2005 10:57PM
I tend to max out about 12. Don't really like going any farther then that. Re: Maximun distance?
Posted by:
Anonymous User
(---.dialup.mindspring.com)
Date: March 07, 2005 11:19PM
After reading these posts, I went out and measured three rods; a 5'6", a 6 footer and a 7 footer. All had the first guide over 15 inches. I measured from the front of the reel. When setting up a rod, I use this little homemade job that holds the fly line at the middle of the reel seat and measure from there.
I just wondered if we're measuring from the same point. C2 Re: Maximun distance?
Posted by:
bill boettcher
(---.250.201.58.Dial1.Weehawken1.Level3.net)
Date: March 08, 2005 05:13AM
I'm talking of the distance between two guides. There is usually a ballpark distance from the reel to the first or butt guide.
I think some placed a piece of tape on the blank to see if the line hit it to tell if there would be line slap Re: Maximun distance?
Posted by:
Anonymous User
(---.dialup.mindspring.com)
Date: March 08, 2005 12:17PM
I think that we're on the same page now. I measured the distance between the butt guide and second guides and it is, indeed, shorte than 15 inches, but I wouldn't be concerned unless I got blank rub or line slap.
I have used the tape method when checking for line slap. I put a piece of tape on the blank and coated the line with carpenter's chalk. Sometimes, line slap was so bad that it looked like I was trying to write my name or something. I learned a lot from these tests. C2 Re: Maximun distance?
Posted by:
bill boettcher
(---.250.45.142.Dial1.Weehawken1.Level3.net)
Date: March 08, 2005 12:34PM
Carpenters chalk, did not think of that. Too lazy to look for the post. Sorry, only registered users may post in this forum.
|