SPONSORS
2024 ICRBE EXPO |
Rod display rack
Posted by:
Brad Musser
(156.75.180.---)
Date: February 14, 2002 03:16PM
Hello Folks! I've been looking for some sort of woodworking plans to build an upright Rod display rack, I',m starting to get to the point were I need someplace to put em all! :-) Looking for something that will hold up to 20 or so rods. I've found prebuilt racks but think I can do things a little cheaper. Any ideas? Thanks! Brad Re: Rod display rack
Posted by:
Butch North
(---.juneau-01-04rs16rt.ak.dial-access.att.net)
Date: February 14, 2002 10:07PM
I used 1 1/2" pvc tubing. Drill a large hole on top side and bottom side of one side of tubing. Then drill a smaller hole about the size of the wood screw you will use on the opposite side of tubing on the top side and bottom side. Then you can mount the tubing to a wooden frame of your choice. Put the frame work on a wooden platform and install a rotating device like a lazy susan or a swivle off an recliner chair to the bottom of platform. Hope this will give you some ideas. Any questions you can e-mail me at northreelrepair@att.net. Sorry, only registered users may post in this forum.
|