SPONSORS
2024 ICRBE EXPO |
Results 31 - 39 of 39
16 years ago
rick brixon
I need help on how to cut the angle for cork tape, for a surf rod, so that it is straight. I am installing it between a butt (already installed) and a similar cork before the reel seat (not installed).
Rick
Forum: rodboard 16 years ago
rick brixon
How many 12" x 12" sheets of birch bark would it take to build a fly rod handle. I don't want to be short.
Thanks,
Rick
Forum: rodboard 16 years ago
rick brixon
I have just finished building the "Homebrew Spine Finder" by Steve Hudson and find that based on what position I place the rod in the finder it will go to one of two positions. The positions are 180 degrees opposite each other. What am I doing incorrectly?
Forum: rodboard 16 years ago
rick brixon
Does anyone recall the issue of RodMaker Magazine that covers using the system for Rods other than fly rods?
Thanks in advance!
Forum: rodboard 16 years ago
rick brixon
Thanks for all the good advice. I am a little nervous about this, but will go ahead anyway
Forum: rodboard 16 years ago
rick brixon
How does one remove the old varnish off of a 50 year old bamboo rod. Is it practical or a waste of time. The one I I was given to rebuild need a full refurbish. Help i have never done this before.
Forum: rodboard 18 years ago
rick brixon
39. MADEIRA Thread
Has anyone used MADEIRA rayon thread to wrap guides on a fly rod or any other rod? Were you successful?
Forum: rodboard |