SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 13 of 13
19 years ago
Dennis Gillotte
Too bad we have to remain out of step with most of the world but unfortunatly when change requires some effort it seems society will opt for the (seemingly) easy route most of the time. Oh well some where down the road maybe.
dennis in pasadena
Forum: rodboard 19 years ago
Dennis Gillotte
I thought I heard some time ago we were going to switch to the metric system. I know when working on cars the metric system is the only one I know as I have only owned German,English,japanese etc. Don't even own any of those funny fraction tools...lol
thanks again for the responses
dennis in pasadena
Forum: rodboard 19 years ago
Dennis Gillotte
Thanks guys ....should be able to figure it out with this info!
dennis in pasadena
Forum: rodboard 19 years ago
Dennis Gillotte
Hi, need a little help with the english equivelents to the metric measurements. I think 25 mm = 1 inch What about cm? Thanks for any help.
dennis in pasadena
Forum: rodboard 19 years ago
Dennis Gillotte
I ran across the paperwork for my Clemens lathe and the date on the receipt was 1985 (man time flies). I lived along the California coast and used it primarily for saltwater rods. But when transfered inland I made a lot of ultralite and misc. freshwater rods. Work took all my attention for some years and the unit was packed away until this year. I retired 5 years ago but the eyes wern't so good a
Forum: rodboard 19 years ago
Dennis Gillotte
Unfortunatly not every paint store has it. As a matter of fact not one paint store in Pasadena,Ca has it or even would order it for me. Going to try and find it on line.
dennis in pasadena
Forum: rodboard 19 years ago
Dennis Gillotte
Tom, I have some titebond II around the house.....is there a big difference between II and III?
Forum: rodboard 19 years ago
Dennis Gillotte
Doc...does that mean if it is a casting rod as opposed to a spinning rod you would turn it over to place the guides?
Forum: rodboard 19 years ago
Dennis Gillotte
One thing I am going to try to find local (driving distance) are blanks. While the initial purchase price might be tempting the 25 or 30 dollar shipping rate nullifies it for me. I live in Southern California and a 45 minute drive down by the coastline presents access to quite a few stores that stock or will order almost any brand of blank.
Forum: rodboard 19 years ago
Dennis Gillotte
Thanks for that input. After sliding it on the blank for another look it stops at just about the perfect position. Fits real tight though.Blank is a Seeker BS706-S
Forum: rodboard 19 years ago
Dennis Gillotte
Hi, been away from wrapping for many years but trying a return trip to a great and rewarding hobby (life). Anyway if I ordered the reel seat just a hair too close is it Ok to mildly ream it to get it lower on the blank? It's a fugi TCS-17 and I will be splitting it. Thanks for any input.
Forum: rodboard 19 years ago
Dennis Gillotte
I take two hand sized pieces of that rubberized toolbox liner sold in rolls and with a piece in each hand gently twist the area just above and below the split as you close it
Forum: rodboard
Current Page: 1 of 1
|