SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 8 of 8
16 years ago
steve hill
As a coatings chemist I would treat frozen CP like I would treat the paint we make. If you suspect freezing the best check is a thin layer cast on glass. Once dry look for particles or streaks cast by hard junk. Don't confuse anf dried air bubbles with gel particles. If coagulated at all you have obviously kicked-out something. Does this hurt CP performance, no clue, but $ loss isn't woth it. So
Forum: rodboard 16 years ago
steve hill
A buddy and I are using disposible razor blades. Easily removed and they are L shaped and small for great holding on to and the bottom part of the L acts as an excellent base to lay flat on the wrap to pressure cut the thread. They don't last too long but with 3-4 per head the wife hasn't missed them.
I am wrapping amature, with 6-7 poles under my belt and I am finding I can get decent close off
Forum: rodboard 16 years ago
steve hill
Moving on to wood handles. Where is the best place/$ to get CA glue/finish? I called the better wood
craft stores up here in the Twin Cities with nothing on the shelf. I see places on the net, but am figuring
there is a prefered supplier.
Forum: rodboard 16 years ago
steve hill
Having made a few decent rod wraps with the standard nylon A size thread, I moved into weaving.
Home made V shaped loom. After 3 attempts I have an ok looking result. Tightness is good and threads not too frayed. Pattern is 50 threads wide by 120 long or so, lots of single left/right maneuvers.
My first questions is, are there different types of threads better suited for weaving?
Forum: rodboard 17 years ago
steve hill
6. EVA grips
Using EVA grips for the first time. Gluing up a ring design.
Q1. Planning on using solvent type contact cement, no?
Q2. Anything better than shaping with sandpaper?
Forum: rodboard 18 years ago
steve hill
New to rod building and thinking about some weaving now.
Where can I find reasonable priced weave patterns?
I work mostly on light action walleye rods, 0.4 butt diameter +, so that should limit me, but 30-40 threads wide is still ok ,no?
Forum: rodboard
Current Page: 1 of 1
|