SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 8 of 8
3 years ago
Albert Daddario
Just finished an inshore rod. Northfork composites SW 703.
Would appreciate suggestions regarding what to use to coat my signature.
Tried epoxy and flex coat in the past and didn’t like the results.
What are you using?
Appreciate suggestions.
Al D’Addario
Forum: rodboard 3 years ago
Albert Daddario
Thanks very much Norman. I’m going to do just what
you suggest.
I really appreciate your help!
Al
Cape Cod Massachusetts
Forum: rodboard 3 years ago
Albert Daddario
Thank you.
Spinning rod 8’
12-14# mono
1- 2 oz lure/bait will be used
Reel is Daiwa SS2600.
Thanks for helping.
Edit: This is the only fiberglass rod I have built. I’m hoping
someone with expertise using fiberglass blanks can help.
I like the soft action of this blank. I just don’t like the clunky old
Fuji guides.
Forum: rodboard 3 years ago
Albert Daddario
I need new guides for this rod. I built it about 30 years ago using Fuji BSHG guides.
Any suggestions for what guides to use?
I still use it for tossing eels from shore.
Thanks for any suggestions.
Al
Forum: rodboard 3 years ago
Albert Daddario
Thanks so much Joe and Mark!
GPS says
20H - 10H - 6L
5 running guides,
Think I’ll go 6mm for the running guides.
Fuji says 6mm and up KT runners don’t need a belly guide.
I’ll finish with a size 6 tip.
All sound good?
Thanks again.
Albert
Forum: rodboard 3 years ago
Albert Daddario
Thanks Joe
Yes, spinning rod using my Penn 4400SS.
Blank is rated 3/4 to 3 oz.
Very calm surf. I catch stripers 20-30 lbs.
Should I check into single foot?
I don’t want to do the micro guide thing.
Just a simple set up using good guides.
Thanks!
Forum: rodboard 3 years ago
Albert Daddario
Building on a Lamiglas tri-flex 84 1m. I want to use KW guides.
This rod will be used to toss eels from shore. 14-20# Fireline.
Does.... 30-25-16-12-10-8 plus tip sound right??
Thanks very much!
Forum: rodboard
Current Page: 1 of 1
|