SPONSORS
2024 ICRBE EXPO |
onix inserts
Posted by:
Stephen Ashcraft
(---.prodigy.net.mx)
Date: December 23, 2001 10:09PM
I saw the marble work that Tom K. did and was wondering if the same would be possible with onix. I'm in Mexico where this material is pretty available. Re: onix inserts
Posted by:
Tom Kirkman
(---.dialinx.net)
Date: December 24, 2001 10:06AM
I am sure you could do it. You just have to hit on the right combination of cutting bit and turning speed. I am not very familar with the properties of that specific material. Find a custom knife maker and I'd bet he or she could give you some tips. Maybe try K&G finishing supplies in Arizona (520-537-8877). They should have some experience with that sort of stuff. .............. Sorry, only registered users may post in this forum.
|