SPONSORS
2024 ICRBE EXPO |
Anomaly on my new blank :(
Posted by:
Tolo Mentes
(193.243.141.---)
Date: May 08, 2024 08:56AM
Hello!
On my new blank which I bought there is a small anomaly: [prnt.sc] What do you think, could this be dangerous for braking when the rod will be under the pressure? Thank you and regards! Re: Anomaly on my new blank :(
Posted by:
Dennis Danku
(---.dyn.optonline.net)
Date: May 08, 2024 10:37AM
Send it back. Dennis J. Danku (Sayreville,NJ) Re: Anomaly on my new blank :(
Posted by:
John DeMartini
(---.res.spectrum.com)
Date: May 08, 2024 10:48AM
I agree with Dennis, return it.
Have fun Re: Anomaly on my new blank :(
Posted by:
Herb Ladenheim
(---.68.237.4.hwccustomers.com)
Date: May 08, 2024 02:50PM
Should not have passed Quality Control Dept.
Herb Re: Anomaly on my new blank :(
Posted by:
Michael Danek
(---.adr01.alma.mi.frontiernet.net)
Date: May 08, 2024 04:29PM
Yup Re: Anomaly on my new blank :(
Posted by:
Mark Hahn
(---.29.18.98.static.ip.windstream.net)
Date: May 08, 2024 06:42PM
If you bought it from a reputable dealer, they will rake it back and replace it. Or at least they should. Re: Anomaly on my new blank :(
Posted by:
Spencer Phipps
(---)
Date: May 08, 2024 09:53PM
Looks like it might be from the cellophane tape wrapped on the blank before baking to me. Is it a mirror finish NFC? Re: Anomaly on my new blank :(
Posted by:
Tolo Mentes
(---.static.siol.net)
Date: May 09, 2024 07:42AM
Hello!
Guys, thank you for your answers ... Here is a picture one more time: [prnt.sc] @Spencer Phipps, now I have better marks where the main problem is ... ;) Best regards and thank you! Re: Anomaly on my new blank :(
Posted by:
chris c nash
(---.atmc.net)
Date: May 09, 2024 09:07AM
Is there any indentation when you run your finger over the marked area or is it smooth ? If it's smooth than I don't think it's a structural defect at all because I also have a few blanks that have marks like that and they perform perfectly fine . If you're seriously bothered by the appearance than you have every right to return it but I highly doubt you will have any issues with it . Re: Anomaly on my new blank :(
Posted by:
Tolo Mentes
(---.static.siol.net)
Date: May 10, 2024 01:14AM
Hmm. Indentation?
There is like one kind of spiral - the blank doesn't look damaged, but it looks like it's not rolled correctly at the end (before the part, where the rod pieces will be connected) ... If it's smooth? Hmm, no - if I go through this "spiral" I can feel it under my fingers. Re: Anomaly on my new blank :(
Posted by:
Michael Danek
(---.adr01.alma.mi.frontiernet.net)
Date: May 10, 2024 06:04AM
If it's done right you wont feel any discontinuity. It may be OK, but it doesn't look right, and we don't know if it's OK. I would not hesitate to return it. Sorry, only registered users may post in this forum.
|