SPONSORS
2024 ICRBE EXPO |
Older skeleton reel seat
Posted by:
Herb Knowlton
(---)
Date: October 20, 2023 06:16PM
A number of years ago, probably around 10-15, I bought a number of machined aluminum fly reel seat skeletons. They were purchased on @#$%& and the seller was very cantankerous. I remember his @#$%& name as BOBO. He couldn’t stand any criticism and was very obnoxious in his replies. I never used the seats and now I am looking to build a couple rods using them. The take a slightly larger diameter insert than the UL3 and do have a mortise. I’m wondering if any of you have used them and what your opinion is.
Thank for the input. Re: Older skeleton reel seat
Posted by:
Tom Kirkman
(Moderator)
Date: October 20, 2023 07:10PM
Do you have a photo?
............. Re: Older skeleton reel seat
Posted by:
Herb Knowlton
(---)
Date: October 20, 2023 07:38PM
I will try to add a photo. Not sure how to do that! Re: Older skeleton reel seat
Posted by:
Tom Kirkman
(Moderator)
Date: October 20, 2023 08:10PM
You can add it to any photo hosting site, including the one linked to this forum and then just copy and paste the photo link in a post here. Without a photo it's going to be hard to advise, unless somebody knows the guy and has used the same seats.
......... Re: Older skeleton reel seat
Posted by:
Ron Schneider
(---.mid.dyn.suddenlink.net)
Date: October 21, 2023 09:11AM
Can you either "mic" or use a dial caliper and give us the OD needed?
(The ID of the skeleton) How long is the threaded section of the skeleton? Best wishes, Ron Schneider Schneider's Rod Shop Mountain Home, Arkansas [www.schneidersrods.com] mtnron40@yahoo.com 870-424-3381 Re: Older skeleton reel seat
Posted by:
woody osborne
(---)
Date: October 24, 2023 09:27AM
seller "BOBO" was john kuehn/angler's roost if that helps. Re: Older skeleton reel seat
Posted by:
Herb Knowlton
(---)
Date: October 24, 2023 12:12PM
Thanks a lot for the reply. John passed around 5 years ago. The reel seats probably came from his connections to Anglers Roost. He was an interesting man and would have been neat to know. One of these days I’ll figure out how to post a photo of the skeleton hardware. . I am experimenting with a reel seat that needs a larger diameter insert and this seat seems to be perfect. I’ve been experimenting for a couple days getting the mortise of the wood insert inlet to match with the radius of the threaded barrel. I have too much time on my hands, but I think I have it! Sorry, only registered users may post in this forum.
|