SPONSORS
2024 ICRBE EXPO |
My Weekend.
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: October 17, 2023 05:21PM
Hello All.
!0/17/2023. I just got my RodMaker 26-5 magazine put back together after leaving it on the roof of my 3 days ago, of coarse it rained “Hard” that night, and I came back to the car around 1100 the next morning only to find it laying in a pile by the right rear tire of my car still soaking wet, so I took it inside and immediately tried to get the staples out without tearing it up to much, did I say all the staples, all 4 of them (Tom Believes in security). Well, I got them out, too bad I can’t say there was no damage, I then carefully separated the pages and laid them on a flat table to dry overnight. Well, they didn’t dry as flat as I hoped they would and the staple damage was more evident now so I took some masking tape and taped the inside of the pages so it would not show so bad I put the pages back together in their right order. As you might guess the pages were still swollen and wrinkled from when they were wet and were not co-operating. They weren’t folding right to re-staple, so I folded them as well as I could and laid 3 “Full” 4inch binders on top of them and left them for this morning, when I got around to it I took 8 binder clips and clipped it down so the pages would not shift while stapling them. At this point I Stapled them 8 times. (It’s actually legible). Tight Wraps & Tighter Lines. Re: My Weekend.
Posted by:
John Cates
(Moderator)
Date: October 19, 2023 10:50AM
Robert
I sent you an email. Regards John Flex Coat Company Professional Rod Building Supplies www.flexcoat.com Re: My Weekend.
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: October 20, 2023 02:47PM
Hello John.
Sorry I did not get it. Tight Wraps & Tighter Lines. Re: My Weekend.
Posted by:
John Cates
(Moderator)
Date: October 23, 2023 04:21PM
I sent it to the email you have on your profile of this page, is that a good email for you?
I want to send you an extra copy of the magazine that I have and I need your mailing address. You can email me at flexcoat@gmail.com Flex Coat Company Professional Rod Building Supplies www.flexcoat.com Re: My Weekend.
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: October 23, 2023 05:09PM
Hi John
I sent you an E-Mail. Thanks again for your concern. See you at the EXPO. Tight Wraps & Tighter Lines. Re: My Weekend.
Posted by:
Tom Kirkman
(Moderator)
Date: October 24, 2023 08:15PM
I've already sent Robert a replacement. Maybe one of these can escape rough handling by the USPS.
........... Re: My Weekend.
Posted by:
Robert A. Guist
(---.res6.spectrum.com)
Date: October 25, 2023 12:37PM
Hello Tom.
Thanks Tom I have already made my reservations for the ICRBE and will see you there. If you want me to bring anything (besides my smiling face) drop me a line. Also, I'm working on another rod for the AT Boys. Thanks again Tom. Tight Wraps & Tighter Line. Sorry, only registered users may post in this forum.
|