SPONSORS
2024 ICRBE EXPO |
What brand guides on 13 fishing rods
Posted by:
Terry Fude
(---.res.spectrum.com)
Date: June 15, 2023 04:25PM
It's a fate casting in white, with micro guides. 1 is bad and shaving the line, so I need to change it, when I figure out which one. They are really small micro guides so can't see any cracks. Any help on what brand guides they use will help.
Thank you T Re: What brand guides on 13 fishing rods
Posted by:
Mike Ballard
(---.nux.net)
Date: June 15, 2023 06:22PM
Take a Q-tip and push it in and turn it around in each guide ring. If there is a sharp edge or crack it will capture a piece of cotton when you pull the swab out. You can also cut a strip of nylon pantyhose and run it through and around the rings. It will catch on any imperfection. Re: What brand guides on 13 fishing rods
Posted by:
John DeMartini
(---.res.spectrum.com)
Date: June 15, 2023 06:45PM
An eye loop may help especially after wiping the guide with a Q-tip.
If you can't find any chips or cracks I would check the reel spool, roller or line guide. Have fun Re: What brand guides on 13 fishing rods
Posted by:
Ross Pearson
(67.3.17.---)
Date: June 15, 2023 08:40PM
"what brand guides they use will help"
800-508-6013 info@13fishing.com They may or may not tell you about the guides used! Re: What brand guides on 13 fishing rods
Posted by:
Evan Cobb
(---.rochester.rr.com)
Date: June 15, 2023 09:27PM
13 uses Fuji guides, the Fate in particular uses Fuji Alconite according to the description on Tackle Warehouse Re: What brand guides on 13 fishing rods
Posted by:
Terry Fude
(---.res.spectrum.com)
Date: June 16, 2023 04:52AM
Thank you everyone I will check them out Re: What brand guides on 13 fishing rods
Posted by:
roger wilson
(---)
Date: June 17, 2023 09:41AM
The other thing you can do it to simply take an exacto standard triangle shaped blade in a standard blade holder.
[www.grainger.com] Simply insert the blade into each side of each guide and while maintaining very light pressure on the blade, spin it around. If there is an issue with a guide, the blade will hang up at the defect. Even extreme pressure of an exacto blade on any ceramic lined guide will have 0 effect on the guide. Best wishes Sorry, only registered users may post in this forum.
|