SPONSORS
2024 ICRBE EXPO |
Guide tapering fixture
Posted by:
Ray Cover
(70.130.247.---)
Date: August 15, 2008 11:00AM THis is a little fixture I came up with to taper small guide feet. It basically is a nylon rod drilled and taped for a nylon screw to hold the guides through the eye so you can grind the foot. I use this with a diamond lap turning at about 200-300 rmp to get a very nice clean taper on guide feet. I use the lap on a GRS power hone that I use for sharpening gravers but you could also use it on an arbor and turn it slow in a lathe or drill press. Sorry, only registered users may post in this forum.
|