SPONSORS
2024 ICRBE EXPO |
Split Grip
Posted by:
Joe Vanfossen
(76.188.58.---)
Date: April 23, 2008 08:30PM This is the handle for my first build. It is built with the Batson tapered foregrip pieces and butt cap with a Batson exposed blank seat. First stupid mistake, didn't put enough rod bond to provide enough lubrication for front bushing on the rear grip, so the eva split a little near the center. I used an o ring as a winding check to hide the mistake, thus having to put one on the other end. Some of the foam needs shaped up a bit. Over all I'm satisfied with this being my first attempt. Not nearly as good as some, but I'm all thumbs and far from a master craftsman. Sorry, only registered users may post in this forum.
|